|
MATERIAL SAFETY
DATA SHEET |
| 1. IDENTIFICATION OF
THE SUBSTANCE/PREPARATION AND OF THE COMPANY |
| Product Name: |
DEMETER |
| Application: |
Desiccant insecticide for agriculture
|
| Company: |
Agil Ltd. |
| Address: |
Hercules 2, Calleva Park, Aldermaston,
Reading, RG7 8DN. |
| Country: |
United Kingdom. |
| Tel/Fax No's: |
| Tel: + 44 (0) 118
981 3333 |
Fax: |
+ 44 (0) 118 981
0909 |
| Emergency Number:
out of hours- |
|
+ 44 (0) 118 926
5589 |
| |
|
+ 44 (0) 118 947
4407 |
|
|
| 2. COMPOSITION/INFORMATION
ON INGREDIENTS |
Substance:
Kieselgur ~ Purified silicate mineral
(E 551c)
CAS Number: 61790-53-2
|
| |
|
| 3. HAZARDS IDENTIFICATION |
None.
However,
Demeter does contain free silicates.
Ensure that atmospheric dust levels
are maintained such that the amount
of respirable silicates in the atmosphere
is <0.4
mg/M3. Long-term exposure to excessive
levels of any mineral dust can lead
to
respiratory problems.
|
|
| 4. FIRST AID MEASURES |
| Inhalation: |
If strong inhalation
of dust occurs it is recommended to
clear the
airways |
| Eye Contact: |
In case
of contact with eyes, rinse immediately
with plenty of water |
|
| 5. FIRE FIGHTING MEASURES |
|
|
| 6. ACCIDENTAL RELEASE MEASURES |
Personal
precautions: Wastes are not classified
as hazardous
Environmental precautions: None
|
|
| 7. HANDLING AND STORAGE |
|
Handling: |
Common
care and ensure low dust levels. |
| Storage: |
Store
in clean dry conditions. Keep container
closed and
ensure label is intact and legible.
|
|
| 8. EXPOSURE/PERSONAL CONTROL |
| Engineering
Measures: |
N/A |
| Control
Parameters: |
None |
| Eyes: |
Wear eye/face
protection. |
| Personal
protection equipment: |
|
|
| |
At high dust
levels and/or workers suffer from
dermatitis or sensitive skin
S36 Wear suitable protective clothing |
|
| 9. PHYSICAL AND CHEMICAL PROPERTIES |
| Appearance: |
Beige
/ Grey powder |
| Odour: |
None |
| pH
of 5% aqueous extract: |
~ pH 4.5 |
| Boiling
point: |
N/A |
| Melting
point: |
>1000oC |
| Flash
point: |
N/A |
| Explosive
properties: |
Non-explosive |
| Vapour
pressure: |
N/A |
| Relative
density: |
325 g/l |
| Solubility: |
Generally
insoluble in common solvents |
|
| 10. STABILITY AND REACTIVITY |
|
Demeter is chemically inert to all
fluids with the exception of hydrofluoric
acid.
Conditions
to avoid: None
Materials
to avoid: Hydrofluoric
acid
|
|
| 11. TOXICOLOGICAL INFORMATION |
Non-toxic.
Excessive exposure to dust may
affect susceptible persons as
follows:
Skin contact: Mild irritation
Eye contact: Mild irritation
|
|
| 12. ECOLOGICAL INFORMATION |
Demeter
is an environmentally compatible
material.
|
| |
|
|
| 13. DISPOSAL INFORMATION |
Disposal must be in accordance with
local and national
legislation.
Dispose
of through an authorised waste contractor
to a
licensed site.
Provided
care is taken to inhibit airborne dust,
normal factory
disposal procedures may be employed
using skips and tips,
then landfill. Spillages may be swept
up. The use of water is
not recommended; surfaces coated
with wet material would
be a slipping hazard.
|
| 14. TRANSPORT INFORMATION |
No special precautions,
other than dry conditions, are
necessary.
|
| 15. REGULATORY INFORMATION |
| LABEL
FOR SUPPLY: |
| |
NONE |
| RISK PHRASES: |
None. However, workers
should be informed of the presence
of crystalline silica and be trained
in the proper use and
handling of this product as required
under applicable
regulations. |
| SAFETY PHRASES: |
S22 Do not breathe
dust
S26 In case of contact with eyes, rinse
immediately with
plenty of water
S36 Wear suitable protective clothing
(susceptible
persons and in dusty conditions)
|
STATUTORY INSTRUMENTS:
|
Health and Safety at
Work Act 1974.
Chemicals
(Hazard Information and Packaging for
supply) Regulations 1994.
Control
of Substances Hazardous to Health Regs
1988 (Si
1657).
Environmental Protection Act 1990. |
| CODES OF PRACTICE: |
Waste management: The
duty of care. |
| GUIDANCE NOTES: |
Health and Safety Executive:-
Occupational exposure limits (EH
40/94)
Classification, Packaging and Labelling of Dangerous Substances Regulations
1984
|
|
| 16. OTHER INFORMATION
|
Recommendations/restrictions:
It is important to follow the inclusion instructions detailed in the Product
Data Sheet. Do not use the product for any other application without obtaining
advice from Agil beforehand.
If this product is for
resale, ensure that the purchaser receives
a copy of this information.
The information herein
is believed to be correct as of the date
hereof but is provided without warranty
of any kind. The recipient of our product
is responsible for ensuring that, where
applicable, existing laws and guidelines
are observed.
|
